Alora Issa VL418021 Bedienungsanleitung

Lies die bedienungsanleitung für Alora Issa VL418021 (38 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 25 Personen als hilfreich bewertet und erhielt im Schnitt 4.1 Sterne aus 8 Bewertungen. Hast du eine Frage zu Alora Issa VL418021 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Issa

VL418021

NOTEIC

• T r far suct out t et caot heimpotantsaegudsandintrionslinedinhisshenn

cov le ct t that may occur.tst be er allpossibondiions andsituaions I mu

undeood hat tainbeoled.hesrsttcaut cerion and care factorsust m flow Te

inions idedsahighendstructarrove p foyor ur fet we y andly recomm that a

liensed,tricianintall hisnic tralecined e st ut.

• T ur tountcorrectlstall staard hisfixte is designedo be med on a y inednd

rouoco throur boithaer T bond or tagon bx ORgh a wiingx w a plstr fame.hex

mubesecounedhee heding.heossbst urely mt to t stcturruotf buil T crar and

happliedshobeused,diingheherdware su uld rectly mount t fixture to t o

utlet

bomake le to correctl t ure.x y mait impossiby alignhefixt

ALSSEMBY ONINSTRUCTIS

WD CAISARNINGS ANUTON

· Make sure is POWERCOMPLETELY OFFat the fuse box

·Have your fixture installed by a qualified licensed electrician

· Prepare everything in a clear area

· Wear gloves at all times during this installation

·Read instructions carefully before you start assembly

· Keep this installation sheet for future reference

1a.1c.4a.1e.2a.1b.2b.

Step 1

Remove fixture from its original package.

Step 2

Separate mounting plate (1c) from canopy (2a) by removing canopy

screws (2b).

Step 3

Attach mounting plate (1c) to electrical junction box (1a) using junction

box screws provided (1e) in hardware package.

Step 4

Make proper electrical connections ( to to blackhotwhite “L”, neutral

“N”, ground to ) with wire nuts (1b) provided in hardware “GND”

package and place driver (4a) inside canopy (2a).

Step 5

Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).

You are now ready to enjoy your fixture.

P.

CDA:ANA19054 28 - Sur V3Z 6Mth Ave.,rey,C B3

USA:3035 ELiRd.V. one Mountan - Las egas, N1V 8908

www.aloram.comood

20230109

1.855.855.8926

TECHNICPOTAL SUPR

1.855.855.8926

tcalpprtlr.cechnisuo@aoalightingom

Please Note:

·This Alora Mood LED fixture comes with pre-wired LED module(s)

·Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with

the module could cause permanent damage

· For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required

· 120V input

Produktspezifikationen