Alula RE118 Bedienungsanleitung

Lies die bedienungsanleitung für Alula RE118 (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 33 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 17 Bewertungen. Hast du eine Frage zu Alula RE118 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

I

N

S

T

A

L

L

G

U

I

D

E

I

Verify proper enrollment and operation using your control panel’s installation manual.

Front slot

Mounting Screw Hole

Wall Clip

Flood and Temp Sensor is an integrated environmental sensor.

It detects ood conditions and reports extreme temperatures.

Features

• Titanium probes for unmatched corrosion immunity

• IP67 rated waterproof enclosure

• GORE

®

vent to prevent seal failure

• 5 year warranty

Enroll the ood zone by placing the panel into wireless

enrollment mode and removing the battery tabs or tampering

the sensor. The freeze and heat zones are disabled by default.

To activate and enroll the freeze and heat zones, remove the

sensor cover and use a wire or paper clip to short the desired

outer terminal to the center terminal. To maximize battery life,

only activate the zones being used.

DL ID Conguration

• Flood ID is the serial number shown on the device.

• Freeze ID is the serial number with last digit

replaced with a 1.

• HeatID is the serial number with last digit replaced

with a 2.

Install by placing the sensor in the location requiring ood or

temperature detection. If desired, the wall clip can be used to

secure the sensor.

Optional Screw Mounting

• Remove the wall clip from the sensor’s body.

• Secure the clip to a wall, baseboard or cupboard

using a #6 screw.

• Slide the sensor’s body down onto the wall clip until

it snaps into place.

Detectswater pooled under the sensor and reports extreme

temperature conditions.

Temperature Trip Points

• Heat alarms when over 100°F (38°C)

• Heat restores when under 97°F (36°C)

• Freeze alarms when under 45°F (7°C)

• Freeze restores when over 48°F (9°C)

To replace the batteries, insert a at blade screwdriver into

the front slot and twist. Slide both old batteries out and the

new batteries in. To reinstall the cover, align the rear latches

and roll the cover forward until it snaps into place.

Resolution Compatibles

RE118 Flood & Temp Sensor

Interlogix

®

Compatible

Produktspezifikationen