APC BE650G2-IT Bedienungsanleitung

APC Unterbrechungsfreies Stromversorgungssystem BE650G2-IT

Lies die bedienungsanleitung für APC BE650G2-IT (16 Seiten) kostenlos online; sie gehört zur Kategorie Unterbrechungsfreies Stromversorgungssystem. Dieses Handbuch wurde von 4 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 2.5 Bewertungen. Hast du eine Frage zu APC BE650G2-IT oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Download PDF

Seite 1/16

Important Safety Information

SAVE THESE INSTRUCTIONS - This manual contains important

instructions that should be followed during installation and maintenance of the

Back-UPS and batteries.

Read these instructions carefully and look at the equipment to become familiar

with the device before trying to install, operate, service or maintain it. The

following special messages may appear throughout this document or on the

equipment to warn of potential hazards or to call attention to information that

clarifies or simplifies a procedure.

The addition of this symbol to either a “Danger” or “Warning”

safety label indicates that an electrical hazard exists which will

result in personal injury if the instructions are not followed.

This is the safety alert symbol. It is used to alert you to potential

personal injury hazards. Obey all safety messages that follow this

symbol to avoid possible injury or death.

DANGER

DANGER indicates a hazardous situation which, if not avoided, will

result in death or serious injury.

WARNING

WARNING indicates a hazardous situation which, if not avoided,

could result in death or serious injury.

CAUTION

CAUTION indicates a hazardous situation which, if not avoided,

could result in minor or moderate injury.

NOTICE

NOTICE is used to address practices not related to physical

injury.

User Manual Back-UPS™

BE650G2-IT and BE850G2-IT

Back-UPS BE650G2-IT/BE850G2-IT2

Product Handling Guidelines

Safety and General Information

Inspect the package contents upon receipt. Notify the carrier and dealer if there

is any damage.

• This UPS is for indoor use only.

• Do not operate this UPS in direct sunlight, in contact with fluids, or

where there is excessive dust or high humidity.

• Do not operate the UPS near open windows or doors.

• Be sure the air vents on the UPS are not blocked. Allow adequate space

for proper ventilation.

Note: Allow a minimum of 20 cm clearance on both front and rear sides

of the UPS.

• Environmental factors impact battery life. Elevated ambient

temperatures, poor quality utility power, and frequent discharges will

shorten battery life. Follow the battery manufacturer recommendations.

• Connect the UPS power cable directly to a wall outlet. Do not use surge

protectors or extension cords.

• The UPS cord shall be connected to an earthed mains socket outlet for

safety reasons.

Battery safety

• Servicing of batteries should be performed or supervised by personnel

knowledgeable about batteries and required precautions.

• APC by Schneider Electric uses Sealed Maintenance-Free Lead Acid

batteries. Under normal use and handling, there is no contact with the

internal components of the batteries. Over charging, over heating or

other misuse of batteries can result in leakage of battery electrolyte.

Released electrolyte is toxic and may be harmful to the skin and eyes.

• CAUTION: Before installing or replacing the batteries, remove

conductive jewelry such as chains, wrist watches, and rings.

High energy through conductive materials could cause severe burns.

<18 kg

<40 lb

18-32 kg

40-70 lb

32-55 kg

70-120 lb

>55 kg

>120 lb

Back-UPS BE650G2-IT/BE850G2-IT

• CAUTION: Do not dispose of batteries in a fire. The batteries may

explode.

• CAUTION: Do not open or mutilate batteries. Released material is

harmful to the skin and eyes and may be toxic.

• CAUTION: A battery can present a risk of electrical shock and high

short-circuit current. Failed batteries can reach temperatures that exceed

the burn thresholds for touchable surfaces. The following precautions

should be observed when working on batteries:

– Disconnect the charging source prior to connecting or disconnecting

battery terminals.

– Do not wear any metal objects including watches and rings.

– Do not lay tools or metal parts on top of batteries.

– Use tools with insulated handles.

– Wear rubber gloves and boots.

– Determine if battery is either intentionally or inadvertently grounded.

Contact with any part of a grounded battery can result in electric shock

and burns by high short-circuit current. The risk of such hazards can be

reduced if grounds are removed during installation and maintenance

by a skilled person.

Inventory

Connect the Battery

Back-UPS Quick start guide



Remove the “Stop! Connect Battery” label from the top cover.



Invert the Back-UPS. Press the battery

compartment cover and release the

tabs. Slide open the battery cover.

bu491a

bu492a

Produktspezifikationen

Marke:	APC
Kategorie:	Unterbrechungsfreies Stromversorgungssystem
Modell:	BE650G2-IT
Akustische Signale:	Ja
USB Anschluss:	Ja
Breite:	130 mm
Tiefe:	365 mm
Gewicht:	4000 g
Produktfarbe:	Schwarz
Akkuladezeit:	16 h
Höhe:	120 mm
Betriebstemperatur:	0 - 40 °C
Relative Luftfeuchtigkeit in Betrieb:	0 - 90 %
Verpackungsbreite:	186 mm
Verpackungstiefe:	441 mm
Verpackungshöhe:	190 mm
Paketgewicht:	4500 g
Zertifizierung:	CE, EAC
Anzahl Ethernet-LAN-Anschlüsse (RJ-45):	1
Warentarifnummer (HS):	85078000
Kabellänge:	1.83 m
Betriebsanleitung:	Ja
LED-Anzeigen:	Ja
Temperaturbereich bei Lagerung:	-15 - 45 °C
Luftfeuchtigkeit bei Lagerung:	0 - 95 %
Geräuschpegel:	45 dB
Batterielebensdauer (max.):	5 Jahr(e)
Formfaktor:	Kompakt
Ausgangsleistung:	400 W
Nachhaltigkeitszertifikate:	RoHS
Verkabelungstechnologie:	10/100Base-T
Eingangsfrequenz:	47/63 Hz
Effizienz:	80 %
USV-Topologie:	Standby (Offline)
Eingangs-Betriebsspannung (min):	- V
Eingangs-Betriebsspannung (max):	- V
Ausgangskapazität:	0.65 kVA
Ausgangs-Betriebsspannung (min):	220 V
Ausgangs-Betriebsspannung (max):	- V
Wellenform:	Sine
Output Frequenz:	47/63 Hz
Stromstärke (maximal):	6 A
Druckanstiegsschutz:	Ja
Akustische Alarm-Modi:	Alarm when on battery, Low battery alarm, Overload alarm
Hot-Swap-Batterie:	Ja
Höhe bei Lagerung:	0 - 4500 m
Kaltstart:	Ja
Automatischer Batterietest:	Ja
Überspannungsschutz-Funktionen:	Digital Subscriber Line (DSL)
Anstieg der Energiemenge:	310 J