APC Smart-UPS SMX120BP Bedienungsanleitung

Lies die bedienungsanleitung für APC Smart-UPS SMX120BP (10 Seiten) kostenlos online; sie gehört zur Kategorie Unterbrechungsfreies Stromversorgungssystem. Dieses Handbuch wurde von 49 Personen als hilfreich bewertet und erhielt im Schnitt 4.0 Sterne aus 25 Bewertungen. Hast du eine Frage zu APC Smart-UPS SMX120BP oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Installation Guide Smart-UPS™ X

External Battery Pack SMX120BP

Inventory

Inspect the contents upon receipt. Notify the carrier and dealer if there is damage.

Safety and General Information

Read the safety information below before installing the external battery pack.

• This external battery pack (XLBP) is intended for indoor use only.

• Do not operate this XLBP in direct sunlight, in contact with fluids, or where there is excessive dust or

humidity.

• The battery typically lasts for three to ve years. Environmental factors impact battery life. Elevated

ambient temperatures, poor quality AC power, and frequent short duration discharges will shorten

battery life.

• Before installing or replacing the batteries, remove jewelry such as wrist watches and rings. High

short circuit current through conductive materials could cause severe burns.

• The batteries are heavy. Remove the batteries prior to installing the unit in a rack.

• Use caution when closing and securing the battery compartment doors. Do not allow the battery cables

to be pinched by the battery compartment doors.

• Always install the XLBPs at the bottom of the rack. The UPS must be installed above the XLBPs.

• The UPS display interface will recognize as many as 10 external battery packs connected to the UPS.

However there is no limit to the number of XLBPs that can be used with the UPS.

Two bezelsTie brackets used to secure

multiple tower units together

1 pair rail cleats

8 pan head screws

1 pair rack-mount brackets

Use 8 flat head screws to secure rack-mount

brackets to the UPS

Use 4 ornamental screws to secure rack-mount

brackets to the rails

Install a cage nut in the rack to secure the top hole

of each rack-mount bracket in a four-post rack

1 screw to secure the battery connector to the

external battery pack

Rack-mount support brackets and hardware

1 pair support

brackets

two-post racks

10 screws

four-post racks

6 screws

6 washers

Produktspezifikationen