Artec SE-2 Bedienungsanleitung
Artec
Nicht kategorisiert
SE-2
Lies die bedienungsanleitung für Artec SE-2 (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 4.1 Sterne aus 1.5 Bewertungen. Hast du eine Frage zu Artec SE-2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/1
-Bass : +/-12 dB at 100 Hz
-Treble : +/-12 dB at 4 kHz
-Balance : MN500K Potentiometer
-Current : 0.16 mA
-Voltage range : 6 V ~ 22 V
-Battery : 9 V Alkaline
Specifications
The products manufactured by ARTEC will be free from defect in workmanship and
meterials for a period of two years from proven date. For warranty, please contact
the autholized dealer or shop in your region.
Limited Warranty
-Bass : +/-12 dB at 100 Hz
-Treble : +/-12 dB at 4kHz
-Balance : MN500K Potentiometer
-Current : 0.16 mA
-Voltage range : 6 V ~ 22 V
-Battery : 9 V Alkaline
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
The plasticiser contained in the rubber feet of this product may possibly react
with the coating of your parquet, linoleum, laminate, or PVC floor and, after
some time, cause permanent dark stains. In case of doubt, do not put the
rubber feet directly on the floor, but use felt-pad floor protectors or a carpet.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal ÿ rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult
your local waste disposal facility.
BASS, TREBLE CONTROL EQUALIZER
SE /SE -A-2 2
SE -A2
S
E
2
SE2
SE -A2
If use a battery, When the indicator goes blinking or no longer lights while an effect
is on, it means that the battery is nearly dead and must be replaced. Also it means
that the voltage of power supply is too low or disconnected if use a power supply
system.
When use the pedal with batteries, Please use batteries to prevent ALKALINE
leaking damage.
When use the pedal with a AC adaptor or DC power supply system, Please use
DC9V (100mAREGULATED
or higher) power supply. Using unregulated or
switching power for IT
system can cause of HUM NOISE of high frequency noise.
Battery & Power
Produktspezifikationen
| Marke: | Artec |
| Kategorie: | Nicht kategorisiert |
| Modell: | SE-2 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Artec SE-2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Artec
1 August 2025
1 August 2025
1 August 2025
31 Juli 2025
31 Juli 2025
11 Juni 2023
11 Juni 2023
Bedienungsanleitung Nicht kategorisiert
- Jahnke
- Lexar
- Eartec
- Mivar
- Gossen Metrawatt
- SXT
- Digital Sputnik
- Rolls
- Nero
- Sonicsmith
- Biltema
- Red Panda
- Showtec
- Engel
- GANA
Neueste Bedienungsanleitung für -Kategorien-
7 August 2025
7 August 2025
7 August 2025
7 August 2025
7 August 2025
7 August 2025
7 August 2025
7 August 2025
7 August 2025
7 August 2025