AXESS AXTO-MZ1 Bedienungsanleitung

Lies die bedienungsanleitung für AXESS AXTO-MZ1 (4 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 65 Personen als hilfreich bewertet und erhielt im Schnitt 4.8 Sterne aus 33 Bewertungen. Hast du eine Frage zu AXESS AXTO-MZ1 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

METRA. The World’s best kits.

™

metraonline.com1-800-221-0932

© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION

Installation Instructions for AXTO-MZ1

REV. 1/21/2020 INSTAXTO-MZ1

(continued on next page)

INTERFACE COMPONENTS

• AXTO-MZ1 interface • 16-pin harness with stripped leads

• 10 to 24-pin “T” harness

TOOLS REQUIRED

• Cutting tool • Tape • Crimping tool

• Connectors (i.e. butt-connectors, bell caps, etc.)

AXTO-MZ1

MAZDA

CX-7 2007-up

CX-9 2007-up

APPLICATIONS

CONNECTIONS TO BE MADE

(to the aftermarket radio)

From the 16-pin harness:

• The Red wires will not be used in this application.

• The Orange/White wire will not be used in this application.

• Connect the White wire to the left front positive speaker output.

• Connect the White/Black wire to the left front negative speaker output.

• Connect the Gray wire to the right front positive speaker output.

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the Green wire to the radio’s left rear positive speaker output.

• Connect the Green/Black wire to the radio’s left rear negative speaker output.

• Connect the Purple wire to the radio’s right rear positive speaker output.

• Connect the Purple/Black wire to the radio’s right rear negative speaker output.

• Connect the Blue/White wire to the radio’s amp turn on wire.

• The Brown wire will not be used in this application.

• Connect the Light Green wire to the parking brake wire (if required).

• Connect the Blue/Pink wire to the VSS or speed sense wire (if required).

• Connect the Green/Purple wire to the reverse wire (if required).

From the 24-pin “T” harness:

• Connect the Black wire to the ground wire.

• Connect the Red wire to the ignition wire.

• Connect the Yellow wire to the radio’s 12-volt battery or memory wire.

Caution: Metra recommends disconnecting the negative battery terminal before

beginning any installation. All accessories, switches, and especially air bag indicator

lights must be plugged in before reconnecting the battery or cycling the ignition.

*Note: Refer also to the instructions included with the aftermarket radio.

KIT FEATURES

• Provides accessory (12-volt 10-amp)

• Used in amplified models

• Provides NAV outputs (parking brake, reverse, mute, and V.S.S.)

• Prewired AXSWC harness included (AXSWC sold separately)

• Adjustable gain control for overall volume

• High level speaker input

• Micro “B” USB updatable

• Retains balance and fade

Produktspezifikationen