BlendMount MT-4015 Bedienungsanleitung


Lies die bedienungsanleitung für BlendMount MT-4015 (2 Seiten) kostenlos online; sie gehört zur Kategorie Detektor. Dieses Handbuch wurde von 29 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 15 Bewertungen. Hast du eine Frage zu BlendMount MT-4015 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/2
Guidelines on Using a Voltmeter to
Locate Power and Ground
1. First set your voltmeter to the continuity
setting (should beep when you touch the red
and black probes together, telling you they are
shorted).
2. Find a ground on the car somewhere, like a
bolt under the dash,
or
a metal cross member.
3.
Put the black probe on that ground, and
touch the back
of
each exposed wire connector
in the mirror harness with the red probe.
4. For each wire that beeps, that means that
wire is grounded. Tum the ignition to the on
position, then back to off, and make sure it
beeps regardless
of
the ignition position.
5
..
Put the voltmeter into VDC mode, to
measure DC volts, turn the ignition to the on
position.
6.
Put the black probe on the ground wire
found
in
#4.
7. Touch each
of
the wires
in
that harness with
the red probe, and note which one( s) gives you
+12-14 volts, turn the ignition off to verify that
the volt readings go down to zero
or
close to
zero.
"Power Up" Your Radar Detector
by TAPPING Into Your
Rear View Mirror's Wire Harness
2
Amp
in line
fuse
Innovative Design
And
Precision Manufacturing
For more information please visit
WWW
.MIRRORTAP.COM
©2014 J28 Design Inc. 06/20
7
28028
34174
4
M i RROR
Radar Detector Power Cord
With
In
Line Fuse
.080" WIDE X .525"
LG
TAP X 15"
OVERALL
LENGTH
RJ11 CONNECTOR


Produktspezifikationen

Marke: BlendMount
Kategorie: Detektor
Modell: MT-4015

Brauchst du Hilfe?

Wenn Sie Hilfe mit BlendMount MT-4015 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten