Cres Cor IFW-63-10-R Bedienungsanleitung

Lies die bedienungsanleitung für Cres Cor IFW-63-10-R (2 Seiten) kostenlos online; sie gehört zur Kategorie Beleuchtung. Dieses Handbuch wurde von 18 Personen als hilfreich bewertet und erhielt im Schnitt 3.7 Sterne aus 9.5 Bewertungen. Hast du eine Frage zu Cres Cor IFW-63-10-R oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

INSTALLATION INSTRUCTIONS

for PULL-DOWN INFRA RED MODELS IFW-63 SERIES

5925 Heisley Road • Mentor, OH 44060-1833

Infra-red Lamps

IFW 63 Series

FL-2219

Rev. 2 (05/06)Page 1 of 2

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

ELECTRICAL SPECS:

VOLTSWATTSAMPSHERTZPHASENEMA

1202502.06015-15

2402751.16016-15

Warmer should be installed by an experienced

electrician.

U.L. and CSA REQUIREMENTS:

A. Wires of warmers to be connected to 75°C wire.

B. Wires are to be installed in conduit.

C. Warmers are not to be installed any closer than 1” from

a wall.

D. Warmers must be at least 16” above a combustible

surface.

HOW TO INSTALL: (See figure at right)

NOTE: Outlet box (7) and screws (5) are to be furnished by

customer.

Pull canopy (2) down over coil cord.

Attach ground wire from ceiling to the “GND” hole in

the plate (4) with screw (6).

Wire the warmer leads to the outlet box (7) leads.

Attach plate (4) to the outlet box (7) with screws (5).

Lower or raise the coil cord to the height you want.

Adjust the tension of the coil cord in the slot as shown.

(a) To increase tension, turn slot clockwise.

(b) To decrease tension, turn slot counter clockwise.

7. Pull up canopy (2) and screw it to the plate (4) with two

machine screws (3).

8. Screw lamp into socket.

1.

2.

3.

4.

5.

6.

DO NOT PULL

DOWN ON CORD

BEYOND THE STOP.

Adjust Coil

Tension

Produktspezifikationen