Cres Cor IFW-64-10-PN Bedienungsanleitung

Lies die bedienungsanleitung für Cres Cor IFW-64-10-PN (2 Seiten) kostenlos online; sie gehört zur Kategorie Beleuchtung. Dieses Handbuch wurde von 14 Personen als hilfreich bewertet und erhielt im Schnitt 5.0 Sterne aus 7.5 Bewertungen. Hast du eine Frage zu Cres Cor IFW-64-10-PN oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

INSTALLATION INSTRUCTIONS

for MODEL IFW-64 SERIES RIGID STEM WARMERS

5925 Heisley Road • Mentor, OH 44060-1833

IFW 64 Series

FL-0314

Rev. 13 (05/06)Page 1 of 2

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

ELECTRICAL SPECS:

VOLTSWATTSAMPSHERTZPHASENEMA

1202502.06015-15

2402751.16016-15

Warmer should be installed by an experienced

electrician.

U.L. REQUIREMENTS:

A. Wires of warmers to be connected to 75°C wire.

B. Wires are to be installed in conduit.

C. Warmers are not to be installed any closer than 1” from

a wall.

D. Warmers must be at least 16” above a combustible

surface.

HOW TO INSTALL: (See figure at right)

NOTE: Item numbers are in parentheses.

Put the canopy (2) over the tube (4) and run the wire

through the threaded nipple of the canopy.

Connect the tube (4) to the canopy (2).

Remove two screws from the crown plate (3) and let

the canopy (2) slide down the tube (4).

Mount the strap (1) to the electrical outlet box with two

screws and nuts.

Wire the warmer leads to the outlet box with two

screws and nuts.

Attach the ground wires, one from the ceiling and the

one from the lamp, to the “GND” hole in the strap (1)

with the green screw.

Screw the canopy (2) to the crown plate (3) with the

two sheet metal screws.

Tighten all tubing connections; fasten threaded end

of bottom stem (5) into the socket assembly (6) and

tighten.

1.

2.

3.

4.

5.

6.

7.

8.

1

2

3

4

5

6

Produktspezifikationen