Sigma STS Bedienungsanleitung
Lies die bedienungsanleitung für Sigma STS (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 37 Personen als hilfreich bewertet und erhielt im Schnitt 4.0 Sterne aus 9 Bewertungen. Hast du eine Frage zu Sigma STS oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/2

080541 / 2
sigmasport.com
SIGMA-ELEKTRO GmbH
Dr.-Julius-Leber-Straße 15
67433 Neustadt/Weinstraße
Germany
SPEED TRANSMITTER
STS
EU-DECLARATION OF CONFORMITY
We, SIGMA-ELEKTRO GmbH, Dr.-Julius-Leber-Str. 15,
D-67433 Neustadt/Weinstraße declare under our
responsibility that the transmitter STS-S-3 are
compliant with the essential requirements and
other relevant requirements of the RED Directive
2014/53/EU and the RoHS Directive 2011/65/EU.
The declaration of conformity can be found at:
ce.sigmasport.com/ats2021
EU-KONFORMITÄTSERKLÄRUNG
Wir, SIGMA-ELEKTRO GmbH, Dr. Julius Leber Str. 15,
D-67433 Neustadt/Weinstraße erklären, dass der
Sender STS-S-3 bei bestimmungsgemäßer
Verwendung den grundlegenden Anforderungen
gemäß RED Directive 2014/53/EU und der RoHS
Directive 2011/65/EU entspricht. Sie nden die
Konformitäts-Erklärung unter folgendem Link:
ce.sigmasport.com/ats2021
UKCA STATEMENT
We, SIGMA-ELEKTRO GmbH, declare that the equipment
above has been tested in our facility and found compliance
with the requirement limits of applicable standards, in
accordance with the Radio Equipment Regulations 2017 and
the Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012. The
test record, data evaluation and Equipment Under Test (EUT)
congurations represented herein are true and accurate
under the standards herein specied.
TECHNICAL INFORMATION
Battery typeCR 2032 x 3 V
Operation temperature-10 °C to 60 °C
Operation frequency112 kHz
Transmission powerMax power <11.37 dBm
INDUSTRY CANADA STATEMENT
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
Le présent appareil est conforme aux CNR Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) il ne doit pas produire de brouillage et
(2) l’ utilisateur du dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est
susceptible de compromettre le fomctionnement du dispositif.
CAN ICES-3(B)/NMB-3(B)
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102
RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la conformité
à l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information canadienne sur l’exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment
should be installed and operated with a minimum distance of 5 millimeters between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu’aucune autre antenne ou émetteur. Cet
équipement devrait être installé et actionné avec une distance minimum de 5 millimètres entre le radiateur et votre corps.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
Caution: If any changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modications not expressly approved by the party responsible for
compliance. Such modications could void the user’s authority to operate the equipment.
The RF Exposure Compliance distance is 5 millimeters.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
− Reorient or relocate the receiving antenna.
− Increase the separation between the equipment and receiver.
− Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
− Consult the dealer or an experienced radio/TV technician for help.
FCC ID: M5LSPD3STS
Produktspezifikationen
| Marke: | Sigma |
| Kategorie: | Nicht kategorisiert |
| Modell: | STS |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Sigma STS benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Sigma
26 September 2025
26 September 2025
14 Juli 2025
8 Juli 2025
2 August 2024
25 Juli 2024
21 Juli 2024
5 Januar 2024
14 November 2022
Bedienungsanleitung Nicht kategorisiert
Neueste Bedienungsanleitung für -Kategorien-
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026
29 Januar 2026