Vestil TDT-50-LD Bedienungsanleitung

Lies die bedienungsanleitung für Vestil TDT-50-LD (1 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 6 Personen als hilfreich bewertet und erhielt im Schnitt 4.3 Sterne aus 3.5 Bewertungen. Hast du eine Frage zu Vestil TDT-50-LD oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Rev. 2/16/2015 TDT-50-LD, MANUAL.doc

Copyright 2015 Vestil Manufacturing Corp. Page 1 of 2

TDT-50-LDSERIES LIGHT DUTY MOLDED POLYURETHANE BINS (0.5YD

3

)

ASSEMBLY MANUAL

FIG. 1: Complete bin assembly

FIG. 1B: Fasten carriage to bin

VESTIL MANUFACTURING CORP.

2999 North Wayne Street, P.O. Box 507, Angola, IN 46703

Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868

Fax: (260) 665-1339

www.vestilmfg.com e-mail: [email protected]

FIG. 1A: Attach casters

Step 2: Fasten the undercarriage to the bottom of the bin at

the four locations highlighted with light-colored arrows

below. To attach the carriage to the bin, use the 4 large hex

head screws provided with the product. Insert the screws

through slots in the cross rails of the undercarriage and into

the binas shown in FIGS. 1A & 1B.

Step 3: Slide a wheel onto each end of the axle. The threaded ends of

the axle should project from the wheel hubs. Secure each wheel to the

axle with hex nuts as shown in FIG. 1C.

FIG. 1C: Attach wheels to axle

Tighten hex nut against metal

hub to secure wheel on axle

Step 1: Fasten the casters (2) to the undercarriage.

[NOTE: Attach casters before fastening undercarriage to

bottom of bin.] Referring to FIG. 1A, insert the threaded

stem of each caster into the threaded bolt hole in the side

rail (of the undercarriage); then install hex nuts on the

ends of the stems and tighten the nuts against the side

rail.

Undercarriage

Side rail of carriage

Hex head

screw

Cross

rail

Large hex head screw

Produktspezifikationen