Vestil UNI-4848-2 Bedienungsanleitung

Lies die bedienungsanleitung für Vestil UNI-4848-2 (14 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 3 Personen als hilfreich bewertet und erhielt im Schnitt 4.6 Sterne aus 2 Bewertungen. Hast du eine Frage zu Vestil UNI-4848-2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

02/05 03-126-121.doc

VESTIL MFG.CO. 1

VESTIL MANUFACTURING CORP.

2999 N. Wayne St., Angola, IN 46703

Ph: 260-665-7586 · Fax: 260-665-1339

E-mail: [email protected] Website: www.vestil.com

MODEL UNI

Serial number ____________

Installation Instructions ……………….....................… 2

Operation Instructions ……………………….……… 3-4

Routine Maintenance & Safety Checks ……………… 5

Exploded Structural Parts Drawing & BOM ………... 6-7

Motor and Transformer Connections ............................ 8

Electrical & Hydraulic Diagrams & BOM ………….. 9-10

Power Unit’s Operation ………………...…..………... 11

Troubleshooting …………………………....………… 12

Safety Label Identification .............................................13

Warranty …………………………………….……..…. 14

IMPORTANT NOTES,WARNINGS AND SAFETY INSTRUCTIONS

Ensure that all employees understand and follow the following.

oRead and understand the owner’s manual before using or servicing

the Uni-Tilt.

oThe load must be removed and the platform supported or fully

lowered before any work is performed on the lift.

oEnsure that all safety and warning labels stay in place and are

legible.

oDo not use the Uni-Tilt if any damage or unusual noise is observed.

oAlways watch the platform and the container carefully when the

tilter is in operation.

oDo not transport the Uni-Tilt with any load on the platform.

oDo not use brake fluid or jack oils in the hydraulic system. If oil is

needed, use an anti-wear hydraulic oil with a viscosity grade of

150 SUS at 100°F, (ISO 32 cSt @ 40°C), or Dexron transmission fluid.

oContact the manufacturer for any needed MSDS information.

♦Do not perform any modifications to the Uni-Tilt without the

manufacturer’s approval. Failure to receive authorization for

changes to the equipment could void the warranty.

♦Maintenance and repairs are to be done only by personnel qualified

to perform the required work. Warranty labor charges will not

receive consideration without prior written authorization by the

manufacturer.

WHEN ORDERING

REPLACEMENT PARTS:

We take pride in using quality

parts on the equipment we

manufacture. We are not

responsible for equipment

problems resulting from the use

of unapproved replacement

parts.

To order replacement or

spare parts for this equipment,

contact the factory.

In any communication with

the factory please be prepared

to provide the machine’s serial

number, which is indicated on

the machine dataplate.

RECEIVING INSTRUCTIONS

Every unit is thoroughly

tested and inspected prior to

shipment. However, it is

possible that the unit could

incur damage during transit.

Inspect the unit closely when

it arrives. If you see evidence

of damage or rough handling to

either the packaging or to the

product when it is being

unloaded, immediately

make a

note of it on the Bill Of Lading!

It is important that you

remove the product’s packaging

upon its arrival to ensure that

there is no concealed damage

or to enable a timely claim with

the carrier for freight damage.

Also verify that the product

and its specifications are as

ordered.

O

WNER

’

S

MANUAL

Produktspezifikationen