Elektrobock PT14-HT Bedienungsanleitung
Elektrobock
Thermostat
PT14-HT
Lies die bedienungsanleitung für Elektrobock PT14-HT (6 Seiten) kostenlos online; sie gehört zur Kategorie Thermostat. Dieses Handbuch wurde von 39 Personen als hilfreich bewertet und erhielt im Schnitt 4.9 Sterne aus 20 Bewertungen. Hast du eine Frage zu Elektrobock PT14-HT oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/6

PT14-HT
PT14-HT
PT14-HT
PT14-HT
PT14-HT
SPATIAL
THERMOSTAT
FOR CONTROL OF THERMOELECTRIC DRIVES
• radiators equipped with thermoelectric drives
• hot water underoor heating distributors with thermoelectric drives
Intended/designed for

ASSEMBLY AND LOCATION
Install the thermostat in a suitable place where its operation will not be aected by the direct ow
of warm air from the heater, sunlight and other interfering inuences. Also avoid mounting on an
exterior wall. The installation height should be approx. 1.5 m above the ground.
Installation may only be carried out by a suitably qualied person!
Installation must be carried out without voltage!
1) Switch o the main circuit breaker.
2) Unscrew the locking screw and remove the front part of the thermostat with electronics (Fig.1).
3) Attach the back of the thermostat to the wall (Fig.2).
4) Connect the wires to the terminal board, make sure that the terminals are suciently tightened
(Fig.3).
5) Attach the front of the thermostat with LCD and secure the thermostat against splitting
locking screw (Fig.4).
6) Switch on the main circuit breaker. If everything is OK, the current temperature is displayed on
the LCD.
ASSEMBLY PROCEDURE
DESCRIPTION
power indication
heating
button for
lowering the
temperature temperature switch
/
button for
raising the temperature
We recommend:
Thermoelectric actuator type NC (valve closed
without voltage), not part of PT14-HT.
Can be ordered at www.elbock.cz order no.0030.

Fig.1 Unscrew the locking screw and remove
thermostat electronics.
Fig.2 Attach the back of the thermostat
on the wall.
Fig.3 Connect the supply wires
according to the scheme.
Fig.4 Place the part with the electronics on the
bottom part and secure with a locking screw.
L
N
e.g.
SEH30.23
NOT USED
holes for installation screws
Produktspezifikationen
Marke: | Elektrobock |
Kategorie: | Thermostat |
Modell: | PT14-HT |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Elektrobock PT14-HT benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Thermostat Elektrobock
10 Juli 2025
1 September 2024
26 August 2024
26 August 2024
20 August 2024
17 August 2024
12 August 2024
6 August 2024
5 August 2024
4 August 2024
Bedienungsanleitung Thermostat
- STI
- Corberó
- Gira
- Z-Wave
- ELV
- Heidenfeld
- Cepra
- Bulex
- Homematic IP
- Panasonic
- Danfoss
- Oreg
- Innogy
- Tado
- HomePilot
Neueste Bedienungsanleitung für -Kategorien-
30 Juli 2025
28 Juli 2025
27 Juli 2025
27 Juli 2025
26 Juli 2025
25 Juli 2025
24 Juli 2025
24 Juli 2025
24 Juli 2025