Forte Lighting 2664-04 Bedienungsanleitung

Lies die bedienungsanleitung für Forte Lighting 2664-04 (1 Seiten) kostenlos online; sie gehört zur Kategorie Beleuchtung. Dieses Handbuch wurde von 7 Personen als hilfreich bewertet und erhielt im Schnitt 4.4 Sterne aus 4 Bewertungen. Hast du eine Frage zu Forte Lighting 2664-04 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

2664-04

Secure glass shade (Q) onto the socket (P) by screwing socket

ring (R) tightly. Install light bulb (not included) in accordance

with the fixture’s specifications. Do not exceed the recommended

maximum wattage.

There are two 18 inch rods (K), two 12 inch rods (L), and

two 6 inch rods (M) included for each fixture. Determine

the correct number of rods needed for proper hanging height.

To lengthen the fixture, add additional rods. If additional

rods are needed, contact the place of purchase to order. To

shorten the fixture, trim the wires to the desired length,

leave at least 8 to 10 inch of wire in addition to the desired

length and slide any excess rods off the fixture’s wires to

discard. Keep in mind that you must use at least the provided

6 inch rods (M) to hang the fixture. Thread the wires through

the rods and pull the wires until taut before connecting the

rods together. Screw bottom rods (M) onto nipples (N) on the

fixture. Screw the nipples of the top rods into swivel posts (I)

of canopy (F). Pull the fixture wires through the top of the

canopy.

Carefully remove all contents from the carton. See the

important notes above. Shut off the power at the circuit

breaker and completely remove the old fixture from the

ceiling, including the old crossbar. Remove the crossbar

assembly from the bag. Crossbar (B) contains several

pairs of threaded holes. Find the pair of holes that matches

the spacing of the holes on the junction box and the fixture’s

canopy. Two mounting screws (A) should be attached to

crossbar (B). You may need to tighten nuts (C) to hold

these screws in place. Pull the house wires through the

center of crossbar (B). Place crossbar (B) over the junction

box so that mounting screws (A) are vertical and aligned

with the hole locations on the fixture’s canopy (F). Secure

crossbar (B) to the junction box by tightening the screws.

screw (E) on crossbar (B) and wrap the fixture’s ground

wire around the green ground screw (E). Use screwdriver

to secure ground screw (E) onto crossbar (B). Tuck all wires

neatly into the junction box.

Produktspezifikationen