JL Audio Stealthbox SB-GM-CFMINI/10W3v3 Bedienungsanleitung

Lies die bedienungsanleitung für JL Audio Stealthbox SB-GM-CFMINI/10W3v3 (2 Seiten) kostenlos online; sie gehört zur Kategorie Nicht kategorisiert. Dieses Handbuch wurde von 13 Personen als hilfreich bewertet und erhielt im Schnitt 4.5 Sterne aus 3 Bewertungen. Hast du eine Frage zu JL Audio Stealthbox SB-GM-CFMINI/10W3v3 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

➔

➔

➔

Stealthbox

®

INSTALLATION GUIDE

SB-GM-CFMINI/10W3v2, JL AUDIO, Inc 2004

Sheet SKU#011115 Revision8/2/2004 Page 1

for the

SB-GM-CFMINI/10w3v2

(1993-’02 Chevrolet Camaro &

Pontiac Firebird)

This Stealthbox is a product which

requires professional installation skills and

tools.

Please read this installation guide thor-

oughly before beginning the project.It

will guide you step by step through the

installation.Several of the steps in this

process may require two people to

accomplish.

It is absolutely vital that the enclosure

be properly mounted to the vehicle

according to these instructions.Failure

to mount the enclosure properly pres-

ents two problems:1) The sub-bass

performance will suffer due to the

movement of the enclosure caused by

the force exerted by the woofer(s) and

2) A loose enclosure presents a serious

safety hazard in the event of a collision

or sudden deceleration.

Please enjoy your JL Audio Stealthbox

responsibly.

STEP 1:

Remove the driver’s side trim panel,

disconnect the speaker wires,if applicable.

STEP 2:

Remove the driver’s side carpet

from the cubby-hole in the corner of the

hatch.this piece of carpet will not be used in

the installation.Vehicle owner should keep this

carpet for possible future use,when removing

the Stealthbox.

STEP 3:

Insert the enclosure into the cubby-

hole,taking care to loft and tuck the wiring

harness above the enclosure as you slide as

you slide it in.Push the enclosure firmly into

place

Make sure the enclosure is all the way

in!!!

STEP 4:

Using the supplied four self-tapping

screws.Seucre the enclosure’s moutning

bracket to the flooring of the vehcile.

Appling black paint to the tops of the screw

heads,just make this isntall that much more

speacial.

Important:Once the screws are thight-

ened,spray under coating onto the

screw tips underneath the car to pre-

vent rust and leaks.Failure to do so

may result in corrosion and could ore-

sent a saftly hazard over time.

STEP 5:

Run speaker wires to the enclosure.

At this time,check the woofer for proper

operation.

START

HERE

Continued on Next Page➔

www.jlaudio.com

➔

➔

Produktspezifikationen