Kuzco Akari LP18537 Bedienungsanleitung

Lies die bedienungsanleitung für Kuzco Akari LP18537 (1 Seiten) kostenlos online; sie gehört zur Kategorie Beleuchtung. Dieses Handbuch wurde von 2 Personen als hilfreich bewertet und erhielt im Schnitt 4.7 Sterne aus 8 Bewertungen. Hast du eine Frage zu Kuzco Akari LP18537 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

INSTALLATION SHEET

LP18537

LED Linear Pendant

START FROM HERE

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

Please Note:

• This Kuzco LED fixture comes with pre-wired LED module(s)

• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary

contact with the module could cause permanent damage

• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required

• 120V input

• Make sure is POWERCOMPLETELY OFF at the fuse box

• Have your fixture installed by a qualified licensed electrician

• Prepare everything in a clear area

• Wear gloves at all times during this installation

• Read instructions carefully before you start assembly

• Keep this installation sheet for future reference

Technical Support: 1-855-855-8926

20211013

1a.

1b.

4a.

1c.

1e.

2a.

2b.

2d.

3a.

1.

2.

3.

4.

5.

6.

7.

Remove fixture from its original package

Separate mounting plate from canopy by (1c)(2a)

removing canopy screws (2b)

Attach mounting plate to electrical junction box (1c)

(1a)(1e) using junction box screws provided in

hardware package

Determine hanging height of fixture by securing rods

(2d) (2a) to canopy and fixture bodyafter feeding (3a)

fixture wires (LED+ and LED-) through rods

Make proper electrical connections between LED and

DC driver, LED- Negative, LED+ Positive using quick

connector provided (See Illustation 1 and refer to

diagram on driver)

Make proper electrical connections ( to “L”, blackhot

whiteground“GND”) to “N”, neutral to with wire

nuts (1b) provided in hardware package and then

place driver inside canopy (4a)(2a)

Attach canopy to mounting plate with canopy (2a)(1c)

screws (2b)

DC

Driver

N

L

G

-

+

Illustration 1

Low Voltage

Produktspezifikationen