Minelab GPX 4500 Bedienungsanleitung

Minelab Detektor GPX 4500

Lies die bedienungsanleitung für Minelab GPX 4500 (55 Seiten) kostenlos online; sie gehört zur Kategorie Detektor. Dieses Handbuch wurde von 7 Personen als hilfreich bewertet und erhielt im Schnitt 3.8 Sterne aus 4 Bewertungen. Hast du eine Frage zu Minelab GPX 4500 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage

Seite 1/55
Instruction Manual
Quick Start
Set the front panel switches to the following positions:
Threshold
Auto Tune
Ground
Balance
Tracking
Fixed
Threshold
On/Off
Hold for FP
Push and release the On/Off switch on the rear
control panel (pg. 25).
Turn the Threshold (pg. 34) control clockwise until a hum
is audible through the headphones.
Raise the coil off the ground and Press the Auto Tune
(pg. 33) button to reduce electrical interference. The
tuning process takes approximately 60 seconds. Do not
move the coil or pass metal objects near the coil during
the tuning process.
Whilst lowering and raising the coil between 25mm and
100mm (1" and 4") from the ground, change the Ground
Balance switch to Tracking (pg. 40). Any variations in the
Threshold will smooth out within 3–5 seconds.
Adjust the Threshold (pg. 34) to a very faint but still
audible level. It should be smooth with only minor
fluctuations.
You are now ready to start searching!
Search
Mode
Soil /
Timings
Ground
Balance
Coil /
Rx
CancelTrackingSpecialDeep
CustomEnhanceFixedDouble D
MNG


Produktspezifikationen

Marke: Minelab
Kategorie: Detektor
Modell: GPX 4500

Brauchst du Hilfe?

Wenn Sie Hilfe mit Minelab GPX 4500 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten