Satel INT-KWRL2 Bedienungsanleitung
Lies die bedienungsanleitung für Satel INT-KWRL2 (16 Seiten) kostenlos online; sie gehört zur Kategorie Detektor. Dieses Handbuch wurde von 21 Personen als hilfreich bewertet und erhielt im Schnitt 3.8 Sterne aus 11 Bewertungen. Hast du eine Frage zu Satel INT-KWRL2 oder möchtest du andere Nutzer dieses Produkts befragen? Stelle eine Frage
Seite 1/16
INT-KWRL2
Wireless keypad
Firmware version 3 int-kwrl2_ 03/ .00 en 21
SATEL sp. z o.o. ul. Budowlanych 66 - POLAND • • 80 298 Gdańsk •
tel. +48 58 320 94 00
www.satel. eu
IMPORTANT
The device should be installed by qualied personnel.
Read carefully this manual before proceeding to installation.
Changes, modications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
The name plate of the device is located on the enclosure base.
SATEL aims to continually improve the quality of its products, which may result in changes in
their technical specications and software. Current information about the changes being
introduced is available on our website.
Please visit us at:
https://support.satel.eu
Hereby, SATEL sp. z o.o. declares that the radio equipment type INT-KWRL2 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address: www.satel.eu/ce
In the EU, th radio equipment is only permitted to operate in the 868 MHz frequency is
band.
The following symbols may be used in this manual:
- note,
- caution.
The INT-KWRL2 wireless keypad enables operation and programming of the INTEGRA and
INTEGRA Plus control panels with firmware version 1.19 (or newer). The device is designed
for work within the ABAX 2 / ABAX two-way wireless system. This manual applies to the
keypad with rmware version 3.00 (or newer), which is supported by:
2: ACU-220 / ACU-280 controller, ABAX
ABAX: ACU-120 / ACU-270 controller (rmware version 5.04 or newer).
The ABAX 2 / ABAX controller must be connected to the expander bus (controller
terminals CKE and DTE) and the keypad bus (controller terminals CKM and DTM)
of the INTEGRA / INTEGRA Plus alarm control panel.
In the ACU-220 / ACU-280 controller, switches 9 and 10 must be set in OFF position.
In the ACU-120 / ACU-270 controller, switch 8 must be set in OFF position.
The keypad is not supported by the ARU-100 and ARU-200 radio signal repeaters or
by the INTEGRA 128-WRL control panel.
Fig. 1. INT-KWRL2 keypad.
Produktspezifikationen
| Marke: | Satel |
| Kategorie: | Detektor |
| Modell: | INT-KWRL2 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Satel INT-KWRL2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Detektor Satel
19 August 2024
18 August 2024
18 August 2024
18 August 2024
17 August 2024
17 August 2024
9 August 2023
Bedienungsanleitung Detektor
- Testboy
- Laserliner
- Garrett
- EVOLVEO
- B/R/K
- Uniden
- AngelEye
- Trotec
- Gewiss
- Inovonics
- XP
- Silent Knight
- X4-Tech
- Denver
- Maginon
Neueste Bedienungsanleitung für -Kategorien-
30 Juli 2025
30 Juli 2025
28 Juli 2025
26 Juli 2025
22 Juli 2025
20 Juli 2025
17 Juli 2025
15 Juli 2025
15 Juli 2025
14 Juli 2025