Simrad Temperature Sensor Bedienungsanleitung
Seiten 1 Nicht kategorisiert
Lies die Bedienungsanleitung für Simrad Temperature Sensor kostenlos online oder lade das PDF herunter. 28 Personen fanden diese Anleitung hilfreich. Frage zu diesem Modell? Stelle eine Frage
*988-10923-001*
What’s in the box
Temperature Sensor
Installation Guide
Tools requiredOverview
Plan the installation
Example of installation
Install the Temperature Sensor
After determining the location, use the temperature sensor as
a template and mark the hull for the screw’s pilot hole. Route
the Temperature sensor and cable to the mounting location. If
routing through the transom, drill a 3/4” hole to accommodate
the Temperature Module.
Attach the Temperature sensor to the hull with one #8 stainless
steel screw and seal the screw (not included) with the below-
waterline sealant compound.
Screwdriver
Drill with 3 mm (1/8” ) and 19 mm
(3/4”) drill bit
1 #8 Stainless steel screw 19 mm
(3/4” ) long
High quality marine grade above/
below waterline caulking compound
The Temperature Sensor converts analog temperature data to
NMEA 2000 data format.
!
You should read all of the installation instructions
before proceeding. Decide where to install all components
before drilling any holes in your vessel.
!
Make sure the Processing unit is inboard and not left
exposed on the open transom.
Other parts required
Temperature Sensor
NMEA 2000 T-Joiner
A Temperature sensor
B Processing unit
C NMEA 2000 connector
A Temperature sensor
B Processing unit
C NMEA 2000 CAN bus backbone
D Livewell
The temperature sensor can be mounted in any location where
you want temperature to be monitored. The most common
applications are transom mounts — to measure surface water
temperature — or in a livewell (when mounting in livewell,
mount as far from pump as possible).
Transom view
Livewell mount
38 mm (1.5”)
10 mm (0.4”)6 mm (0,2”)
A
B
C
46 cm
(18”)
3 m
(10’)
Dimensions
Connect the Temperature Sensor to the network
A Temperature sensor cable 3 m (10 ft)
B Temperature Sensor
C NMEA 2000 CAN bus backbone
D 12 V DC Power supply. Connect via a switch and 5 amp
fuse
Specications
Temperature Range between -20 and 80 degrees Celsius.
PGNs transmitted
59392 – ISO Acknowledgment
60928 – ISO Address Claim
126996 – Product Information
65285 - Temperature with Instance
A
A
B
B
C
C
D
D
Produktspezifikationen
| Marke: | Simrad |
| Kategorie: | Nicht kategorisiert |
| Modell: | Temperature Sensor |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Simrad Temperature Sensor benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Nicht kategorisiert Simrad
Simrad WM-3 Bedienungsanleitung Simrad StructureScan HD Transom Bedienungsanleitung Simrad Sensor Bedienungsanleitung Simrad SonarHub Bedienungsanleitung Simrad Active Imaging HD (Thru-Hull) Bedienungsanleitung Simrad NSS 4 Bedienungsanleitung Simrad NEP-3 Bedienungsanleitung Simrad S3100H Bedienungsanleitung
Beliebt in Nicht kategorisiert
Simrad Fluid Level Sensor Bedienungsanleitung Simrad SI80 Bedienungsanleitung Simrad PSI-1 Bedienungsanleitung