Perel EWL512T Bedienungsanleitung

Perel Beleuchtung EWL512T

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Perel EWL512T (18 Seiten) in der Kategorie Beleuchtung. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/18
V. 06 09/11/2021 2 ©Velleman Group nv
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment. Do not dispose of the unit (or batteries) as
unsorted municipal waste; it should be taken to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service. Respect
the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this
device into service. If the device was damaged in transit, do not install or use it and
contact your dealer.
2. Safety Instructions
Read and understand this manual and all safety signs before using this appliance.
CAUTION Risk of electric shock. Do not open the appliance.
This appliance is not suitable for dimming.
IP class 65. Suited for outdoor use.
This device can be used by children aged from 8 years and above, and persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning the use of
the device in a safe way and understand the hazards involved. Children shall not
play with the device. Cleaning and user maintenance shall not be made by children
without supervision.
For non-replaceable light sources:
The light source of this luminaire is not replaceable; when the light source reaches
its end of life, the whole luminaire shall be replaced.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is
damaged, the luminaire shall be destroyed.
All cords and cables should be routed so that they will not be walked on or pinched
by items placed upon or against them. Pay particular attention to the point where
they exit the unit.
Remove all flammable materials close to the device before switching on.
Do not install the device on a flammable surface (linoleum, carpet, wood, paper,
cardboard, plastic, etc.).
Protect this device from heat sources such as radiators, heat registers, stoves, or
other appliances (including amplifiers) that produce heat.
Do not remove the cover under any conditions. There are no user-serviceable parts
inside. Never operate this device when its cover is removed.
V. 06 09/11/2021 3 ©Velleman Group nv
Do not operate a visibly damaged device. Do not attempt to operate this device if
the power cord has been frayed or broken.
Always mount this device in a safe and stable manner. Mount this device in an area
that will allow proper ventilation. Allow about 15 cm between this device and a wall.
This device should only be serviced by qualified service personnel.
Do not use the luminaire with a cracked or broken protective shield. Disconnect
immediately from the mains. The protective shield is not replaceable.
Familiarise yourself with the functions of the device before actually using it.
Always make sure to connect the device to an alternating current matching the
value stated on the device.
Always install the device in a well-ventilated location.
In the event of an operating problem, stop using the device immediately.
Never try to repair the device. There are no user-serviceable parts inside the device.
Refer to an authorized dealer for service and/or spare parts.
3. General Guidelines
Refer to the Velleman ® Service and Quality Warranty on the last pages of this
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
Nor Velleman Group nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical…) arising
from the possession, use or failure of this product.
Keep this manual for future reference.
4. Operation
General Operation
1. Place the work light on a flat, stable and non-slippery surface.
2. Insert the power plug into the mains to switch on the appliance.
3. Switch off after use by pulling the plug from the main s.
Mounting Bracket
1. Slightly loosen the fixing knob.
2. Adjust the angle as desired.
3. Re-tighten the fixing knob.
1. Pull the locking tab to unlock the leg and fold out the tripod leg until locked.
Repeat for the other two legs.
2. Untighten the post locks and pull the post up to the desired height. Lock the posts.
3. Unscrew the bolt on top of the post, place the bracket of the light on top of the
post and fix tightly with the bolt.
4. Proceed in reverse order to demount.


Marke: Perel
Kategorie: Beleuchtung
Modell: EWL512T
Breite: 209 mm
Tiefe: 30 mm
Gewicht: 3450 g
Produktfarbe: Black, Orange
Internationale Schutzart (IP-Code): IP65
Höhe: 148 mm
Energiequelle: AC
Höhenverstellung: Ja
AC Eingangsspannung: 220 - 240 V
AC Eingangsfrequenz: 50 Hz
Typ: Freistehende Arbeitsleuchte
Menge pro Packung: 1 Stück(e)
Kabellänge: 5 m
Lampentechnologie: LED
Anzahl an Lampen: 1 Glühbirne(n)
Lichtleistung: 2050 lm
Gesamtleistung: 20 W
Ständer enthalten: Ja
Farbwiedergabeindex (CRI): 70
Farbtemperatur: 4000 K

Brauchst du Hilfe?

Wenn Sie Hilfe mit Perel EWL512T benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Bedienungsanleitung Beleuchtung Perel

Bedienungsanleitung Beleuchtung

Neueste Bedienungsanleitung für -Kategorien-